Do
I need extra material for rolling?
In certain cases
we can curve section and plate from the exact length.
You will need to consider the following:
Width
of section
25mm wide
30mm wide
40mm wide
50mm wide
60mm wide
75mm wide
100mm wide
125mm wide
150mm wide
178mm wide
203mm wide
254mm wide
305mm wide
356mm wide
406mm wide |
Allowance
per bar
200 mm per bar
250 mm per bar
300 mm per bar
350 mm per bar
2000mm per bar
2500mm per bar |
If the section is curved to a radius 100 times the section width
or over
you will not need extra material as the straight end will not be
noticeable.
If the section is curved to a radius under 100 times the section
width
you will need the following extra material
Picture of scrap ends
|
